"Five-Minute Photo Coasters DIY Materials You'll Need Ceramic tiles (4x4 inches) Mod Podge or clear adhesive sealant Foam brush Printed photos or decorative paper Felt pads or cork sheets Step-by-Step Tutorial: 1. Prepare Your Tiles: Clean and dry the ceramic tiles thoroughly. 2. Cut Your Photos: Trim your printed photos or decorative paper to fit the size of the tiles. 3. Apply Adhesive: Use a foam brush to apply a thin layer of Mod Podge or clear adhesive sealant to the surface of the tile. 4. Attach Photos: Carefully place the trimmed photos or paper onto the adhesive-coated tile, smoothing out any wrinkles or bubbles. 5. Seal the Surface: Once the adhesive is dry, apply another layer of Mod Podge or sealant over the top of the photo to seal it and protect it from moisture. 6. Add Protective Pads: Attach felt pads or cork sheets to the bottom corners of the coaster to prevent scratching surfaces. 7. Let It Dry: Allow the coasters to dry completely before using or gifting them. 5. Seal the Surface: Once the adhesive is dry, apply another layer of Mod Podge or sealant over the top of the photo to seal it and protect it from moisture."